When the input voltage is over than 2.5V, the output code is overflow. You can see the code of 2.51V is start with "8".

I am using the following configuration and setup. All readings start to drift significantly around 80 C to 125 C. Any idea why is that?

our IT dept. installed the GUI on my computer. After starting it admin rights are needed to proceed. Of course our IT does not like that at all. They might let me use your GUI, if they knew what files ...

IF I AM USING ONLY BPSK MODULATION (NEED ONLY ONE BIT) CAN I CONNECT ONLY THE MSB BIT AND LEAVE ALL THE OTHERS “NC” OR DO I HAVE TO CONNECT TO ALL 8/16 DIFF PAIRS DEPENDING ON BYTE/WORD MODE This ...

I am looking for the silent installation parameters for the setup ADS8681_EVM.exe. It should install ADS8681, National Instruments software and the Windows driver package - Tesys Instruments silent. I ...

The customer has a question about the input rang of AD8668 from ADS8668 user guide. If connect negative input to GND that input voltage just applying only 100mV? or accept 100mV offset into negative ...

I will contact you offline to assist.

My customer is asking for the power consumption in high temperature 125C. Do you have test data for this power consumption. If you don't have this parameter, do you have experience that how high for ...

Have you tried reinstalling the GUI? If that doesn't work, there may be some issues with the drivers interacting with your PC. If reinstalling doesn't work, I could ...

One of my customers is considering using DAC8551 for their new products. They want to use DAC8551 like a voltage dividing resistor. Also they want to input 170Hz AC signal has 0V-5V amplitude to VREF ...

We are using ADS124S108 for measurement of PTC1000 based temperature sensor in 3 wire configuration. Attached schematic for your reference. For board bring up i did following tests : 1. First testing ...

Hi, we're looking at producing the CDCE6214-Q1 with a VCTCXO; unfortunately all of the oscillators that are suitably well stocked have single-ended peak-to-peak (clipped sinewave) output voltages of ...